Ramps 1.4 Fan Extender Ultimaker - 3D Printer The humidity is regulated by

The humidity is regulated by large desiccant bags that absorb moisture from the air inside the PolyBox™

Flame Orange

Expert testing ensures you can count on exceptional results right from the start

Standard fan 12/24V 40x40x10mm 2pin molex connecter (fits mots mainboard)

Dimensions of the ribbon: L: 24 cm

Ramps 1.4 Fan Extender Ultimaker - 3D Printer The humidity is regulated byInfor: Want to connect a firmware controlled FAN to RAMPS board directly when you build or upgrade your printer with to DUAL EXTRUSION (2 extruder) including a heated bed, but found that all the output ports (D8,D9,D10) will be used? The RRD FAN EXTENDER is exactly what you need in this case. It is a plug and play solution to mount the FAN for DUAL EXTRUSION setups with RAMPS1. 4. But instead of adding only one additional output port the RRD FAN