PoE Splitter with MicroUSB Plug - Isolated 12W - 5V 2.4 Amp ADA_Thermal Printing Note: the addresses of the

Note: the addresses of the speech synthesis module and micro: bit motor driver board are the same

com/products/15162)

and it must be connected to the SDATI

A standard 3-pin power and control cable is attached and all hardware listed below is included

com/products/15597) on the transmitter and the stock 1/2 wave dipole antenna on the receiver

PoE Splitter with MicroUSB Plug - Isolated 12W - 5V 2.4 Amp ADA_Thermal Printing Note: the addresses of thePower over Ethernet (PoE) splitters can make your project wiring a breeze and best of all they work to connect any 802. 3af capable router to any Ethernet device, even if it doesn't natively support PoE! The splitter takes a unified PoE signal (data and power) from one RJ 45 cable, and then separates the data (Ethernet) and power (5 VDC regulated) into two different lines for non PoE devices. This is an economical, practical, high performance, and