Elektor DIY LiPo Supercharger Kit (by GreatScott!) SF_Capacitors These regulators have a power-save

These regulators have a power-save mode that activates at light loads and a low quiescent (no load) current draw

This is the Adafruit Feather 32u4 Bluefruit - our take on an 'all-in-one' Arduino-compatible + Bluetooth Low Energy with built in USB and battery charging

Command Action Decimal Hex 80 0x50 Ranging Mode - Result in inches 81 0x51 Ranging Mode - Result in centimeters 82 0x52 Ranging Mode - Result in micro-seconds 160 0xA0 1st in sequence to change I2C address 165 0xA5 3rd in sequence to change I2C address 170 0xAA 2nd in sequence to change I2C address

* **Pressure

IN2 HIGH Inverted control input for OUT2

Elektor DIY LiPo Supercharger Kit (by GreatScott!) SF_Capacitors These regulators have a power-saveThe Elektor DIY LiPo Supercharger Booster (developed the electronics engineer YouTuber GreatScott! and produced by Elektor) can charge a single cell LiPo battery and protect it against the effects of overvoltage, overload, and short circuits. Additionally, it can boost the battery voltage to 5V or 12V. The boosted output voltage is protected by an 'eFuse' IC outputting 1. 52A at 5V or 0. 76A at 12V maximum. The charger part of the circuit needs a +5V