PrintaClean - 250ml Samples - Alle mærker The heatbed is designed with

The heatbed is designed with 4 holes

Suitable for

Highly Soft Flex is located in 85A

Spartel 50mm

Despite its impressive robustness

PrintaClean - 250ml Samples - Alle mærker The heatbed is designed withPrintaClean 250ml PrintaClean If it's hard to get your glue off the building board, PrintaClean is the solution! PrintaClean can clean your building board. Allow the build plate to cool to room temperature. Then remove the build plate from the 3D printer and spray a generous amount of PrintaClean on it. Let it sit for 20 30 seconds to loosen. Wipe off any residue with a piece of paper. Repeat if necessary. PrintaClean If it's hard to get your glue off